Packaging Details
- Unit Type: piece
- Package Weight: 1.3kg (2.87lb.)
- Package Size: 21cm x 11cm x 14cm (8.27in x 4.33in x 5.51in)
New Brushless DC Submersible Pump Solar / Floor Heating Pump High Temperature
Water Cooling JT800 9-24v 1200MA 7 Meters 1150L/H
Notice : when the parcel arrived to your customs ,please pay the
tax and pick up the parcel ,we are not responsible for
any customs duty or import tax
if your place is remote ,then need to pay 35usd .
Picture showing :
Specification:
Product Name: 24V Brushless DC submersible pump
Model: JT800
Voltage: 9-24v (prohibited super 24v)
Current: 1200MA
Maximum head: 7 meters
Maximum flow: 1150L / H
Water pump outlet diameter: four external thread, diameter 20MM, diameter 12MM
Water pump inlet diameter: four external thread, diameter 20MM, diameter 12MM
Matching power: input (AC100-240V, 50 / 60Hz), output (DC 24v, 2A)
Size: 21 * 11 * 14cm
Weight: 1KG
Applicable medium: water
Uses: refrigeration system, water circulation system, solar collector cycle, solar temperature cycle,
water heater water pipe cycle (to achieve a hot water), solar to warm, mattress, to warm, fountain
and so on.
Maximum operating temperature: resistant to 120 degrees high temperature. Water pump can be diving
at room temperature, high temperature can not dive. (The pump is made of high temperature resistant
materials 200 degrees)
product manual:
1. Do not run overpressure. 24V version of the highest is 24V. 5AH above the capacity of the battery is
fully charged if there is no pressure limiting measures, will be serious overpressure, can not guarantee
their own power supply voltage first test.
2. Do not use AC power, router power, computer cat power and so many are similar to the exchange,
can not use!
Ripple problem (the most vulnerable to the problem): Many DC transformers are half-wave rectifier, the
result is a lot of AC components in the DC, the pump will be bad! Brushless pumps must be full-wave
rectified! Do not know please consult professional!
3. Head problem: head 3.2 meters is not to say that the power supply can spray 3.2 meters high, the
head is connected to the water pipe, the water column in the vertical height of the water pipe. Jet height
is much lower than the head!
4. The use of regulated power supply current shall not be less than 2A.
5. This section of the pump is prohibited from unauthorized dismantling, because the ceramic shaft,
the sleeve is a precision installation, non-professional demolition will be difficult to recover. Privately
disassembled the quality problems caused by the need to bear their own buyers!
6. Do not allow ferromagnetic impurities, particles into the magnetic actuator and bearing friction; in the
transport of easy crystallization or precipitation of the media after the timely rinse (operation is: after the
pump to the pump after filling the water, running 1min after the discharge clean); When transporting media
with solid particles, filter at the pump inlet.
7. One end of the pump is best to use bellows or hose connection, you can arbitrarily set, that is, will not
damage the pump is also easy to connect. When you take the pump, you can use the wrench and other tools.
-->