Packaging Details
- Unit Type: piece
- Package Weight: 25.000kg (55.12lb.)
- Package Size: 50cm x 50cm x 50cm (19.69in x 19.69in x 19.69in)
Free by DHL 2015 Third Generation Autoclave OCA LCD Bubble Remove Machine Lager size for Glass Refurbish without screws locked
Picture showing :
Description:
Can not clean bubble causes
1. OCA plastic edge of the screen did not completely closed, under a certain pressure will only make the screen more air to enter. (Usually in four sides of the screen).
2. The temperature is too high will OCA rubber chemical reaction to form small bubbles (usually in the middle of the screen form dense small bubbles).
Our bubble remover machine
Package Size: 500*500*500 mm
Working Inside size about: Diameter 160*Depth 200mm
Warning
When used, must be confirmed no pressure before opening the lid!
Ping-hand thread slip teeth, must be replaced before use!
Note that when using the temperature setting is too high!
1: Press the power button,
Time setting : 10-15 minute M: minutes, H: Hours , S: seconds
2: temperature control: 30-50 degrees
[Appears difficult Bubble increase 60-80 degrees, the time for 20 minutes]
SET ---- into the adjustment
> ---- Move
---- up
---- down
3: Press the green heating button
4: Put screen in, closed, locking handle
5: Press the start button and start working.
6: Turn to the right of the black button to select: Auto [time out, the auto exhaust]
7: 5-6 kg of pressure on the line display. [Water separator can be adjusted]
8: checking and ready to leave. Time to auto exhaust.
9: Check barometer shows 0, remove the screen out.
-
Note : Please remember to contact us if you need more other LCD screen refurbish machine & Mobile Phone Replacement Parts .
We will try our best to help you !! Thanks.
Package Included:
1 x Bubble Remove Machine