|
aHR0cDovL2ZyZWVzaGlwLmNvLmty Item specifics Packaging Details - Unit Type:
- piece
- Package Weight:
- 0.100kg (0.22lb.)
- Package Size:
- 20cm x 20cm x 5cm (7.87in x 7.87in x 1.97in)
p> C7-type coordinate shaped eyepiece 0.1 feet (10/100) 0.1 Coordinate shaped eyepiece ruler, vertical and horizontal coordinates scored a length of 10mm, each divided into 100 equal portions, each dividing the value of 0.1mm, slide diameter Φ19mm.
C Series microscope micrometer micrometer this set will help you to make a quantitative analysis of the microscopic world, make your hand microscope features greatly expanded. Appropriate complexes, visual micrometer, and can measure the diameter of the dust, fiber and other fine material, length, and their dispersion. In addition, the microscope can be used to check that you are using magnification, field of view and other technical parameters of the line is accurate. So, this is all set micrometer microscope department of health, disease prevention, environmental protection, education, testing and other textile fibers, simple and practical detection tools. Eyepiece micrometer Installation instructions:
When ocular micrometer installation, the bottom half of the first eyepiece unscrew the eyepiece micrometer into the lower half of the inside, if you are a standard microscope , it will be just stuck . Then spin on it. For details, see the following : Material preparation : Clean gloves , ready anhydrous ether , ethanol , ( 7:3 mix ratio, wipe ) , cotton ( lens cleaning paper also available) . Installation 1 Carefully open the eyepiece micrometer packaging, unscrew the eyepiece , the installation, which saw the vision upright clear image . 2 sets of feet to open the packaging , carefully take the introduction of foot ( also known as the ruler ) , placed on the microscope stage . 3 in accordance with normal procedure , see the scale of the line sets foot black standard line in the field of vision . 4 Adjust the eyepiece micrometer and sets foot, so all ocular micrometer scale line and station -foot tick as much overlap . 5 Count the number of cells in the multiple sets of feet under the eyepiece micrometer scale line and the nearest line sets foot represents, 6 number to the number of cells with X 10μm, now is the length of the eyepiece micrometer scale . 7 by now been divided by the total length of the eyepiece micrometer cell number , and get every scale length is a multiple of the grid in each of the representative . For example: Sets foot scale length is 1mm, namely 1 000 μm, a total of 100 small squares , so each cell = 1000/100 = 10 μm Eyepiece micrometer Assuming you are using a 100X objective now is , will the left eyepiece micrometer and sets foot alignment. You see a side of the rightmost aligned sets foot in the first 10 cells and ocular micrometer in the field of vision, so all this time each eyepiece micrometer scale is such that counted : 10 ( sets foot coincides with ocular micrometer to the right of the grid ) X 10μm ( Taiwan -foot length of each cell ) = 100μm ( total length of the eyepiece micrometer scale of ) ; 100 μm ( micrometer eyepiece total length scale ) / 100 cells ( total cell number ocular micrometer ) = 1 μm / grid . At this point record 100 X, 1 μm / grid . 8 remaining objective is the same multiple operations. 9 would be placed next to the data recorded under the microscope , each user must remember. 10 If the surface is not clean ruler can be used in accordance with good cleaning fluid and gently wipe from the inside out in a clockwise direction , can be installed dry after use . 11 Do not hand when operating in direct contact lenses to prevent pollution mildew .
|
|
|
|
|