Product Features:
K-302 is a high-intensity UV-curable acrylate adhesive, good versatility good storage stability. Dedicated
to the bonding glass and various metals fixed, for glass, crystal and metal, such as: aluminum, carbon steel,
stainless steel, galvanized steel, etc. have a good bonding effect.
Key performance indicators:
Appearance: colorless or pale amber liquid
Viscosity cps: 600 ± 100 (Brookfield DV-II viscometer at 25 ° C, SC 4-15/150rpm)
Hardness (Shore D): 69 (GB / T 531-1999 curing test)
Elongation%: 120 (GB / T 528-1998 curing test)
Typical curing nature:
K-302 will be cured under ultraviolet light, the sun will slowly solidified. Cure rate, depth, and ultimately curing
effect is dry and UV light source, exposure time, the transmittance of the material and other factors.
Recommended to determine the specific curing time by experiment.
Positioning time:
2mm thick ordinary glass: 10 seconds-F20T8 BL UV lamp; 6 seconds-125W PHILIPS fluorescent high pressure
Sufficient curing time:
2mm thick ordinary glass: 300 seconds-F20T8 BL UV lamp; 200 seconds-125W PHILIPS fluorescent high pressure
Use these steps:
1 . Depending on the material surface treatment , surface dry and clean , no weak boundary layer ;
2 . interface adhesive bonding material on the need for continuous coating, be careful not to disperse ;
3 . light positioning the glue into the short ultraviolet curing lamp radiation, until the hand nudging fixed;
4 . to remove the excess glue with a knife to scrape the glue overflow , or a soft cloth , paper towel and gently
erase the excess glue can also be dipped in acetone, alcohol wipe ;
5 . full cure time high radiation , until fully cured , note the temperature is not too high ;
6 . dipped in acetone, alcohol, cleaning materials with a soft cloth or paper towel and gently wipe the bonding good
material .
Instructions for use:
1 . the adhesive surface clean, dry and free of grease , you can wipe with acetone , hair dryer .
2 . the UV lamp positioned curing , the curing rate is dependent on the glue to absorb light energy from the
light source associated with , the light transmittance material and other factors .
3 . the operation should not squeeze too hard to be sticky , and shall not be repeatedly moved apart
adherend.
4 . using the rest of the glue not fall back to the original packaging to avoid contamination.
Note:
Avoid contact with eyes, skin and clothing . This pair of eyes and a slight skin irritation. If accidentally
splashed into the eyes , rinse immediately with plenty of water , as there does not need to go to hospital.
Rinse immediately with soap and water after skin contact. Please wash before they can wear the clothing.
Do not allow contact with children .
Storage: This product is sensitive to light and heat , you need storage in a cool, dry place, away from light
below 28 ° C, valid for one year .