24V 10A 12V over current blocking protection board
DC motor overload protector positive inversion digital display
Schematic diagram of panel products
Schematic wiring products
Product size
Operating instructions:
1. Through the DC power supply, the first set, set and then press the start button
Two through12VElectric (the default), the display panel light, display the current value of the real value of the current, unit, amp. The controller is high speed detecting current state, current value mantissa will flash.
Three According to a set of keys, the lower right small digital tube light, display01Then, press the set button, switch table setting function:
01 | Forward current protection to value, this value is overload, setting range0.1A to 20A |
02 | Reverse current protection value, to achieve this value is overload, setting range0.1A to 20A |
03 | Forward start delay protection value. Do not overload detection when the motor starts after a period of time, to shield the motor starting process overload. set range0.1-4 seconds |
04 | Start delay protection value, with the other03. |
05 | Forward overload delay protection value. To achieve overload protection under the condition of satisfying a certain period of time to stop, to remove the load disturbance.set range0.1-4 seconds |
06 | Reverse overload delay protection value, with the other05. |
07 | The input mode key, at present only3A model |
Working mode07The options table, with overload protection function.
00001 | When you press the button A and B motor according to the corresponding direction of rotation of the motor stop button up |
00002 | Click the button A or B that let go, according to the corresponding motor rotation direction, again press any button to stop the motor. |
00003 | Cycle (buttonAPress the motor to rotate in a positive direction buttonAThen press the motor to rotate in the opposite direction) |
| |
| |
Note that this product is a non overload protection device, current meter, the current value of relative value without calibration.
Locked rotor current is less than 0.5A of the motor is not suitable for the use of this product.
12V 24V two optional, in order to prevent the wrong goods, please note in the order, not stated in the order of all customers 12V products.