Before you buy, please read here and the specification or contact with us.
Note: What rivet biggest length can the riveter can pull off? Itdepends on the riveter
stroke, take stroke 17mm as an example, minus the stroke waste 5mm, the riveter gun
with 17mm stroke, then it can pull off at most 12mm long rivets, and make sure the
working air pressure 6.5 bar to 8 bar and the air hose inner diameter at least 6.5mm.
Note: When riveting aluminium rivets, the working pressure should be 6-8kgf/cm2 (6-8bar)
When riveting steel rivets, the working pressure must be 6.5-8kgf/cm2 (6.5-8 bar)
Cut off the air, if you want to mantaince the tool or change any part.
Note: Please do not add any oil into the Air Inlet of the Rivet Gun,
otherwise it will decrease the rivet gun power and shorten the using life.
Cautions:
1. It is forbidden to add lubricating oil or pneumatic tool oil from the air inlet.
2. The air compressor needs to be equipped with a water filter.
3.Select the gun nozzle corresponding to the rivet to work.
4. After using the tool for a period of time, clean the impurities in the gun head shell, claw sleeve, end cap and claw thread. Also check the hydraulic oil for bubbles, less oil, deterioration, and if necessary, refill the hydraulic oil.
5. The working pressure must be within 5-7 Bar. If the air pressure is not in this range, be sure to adjust it before using it.
6. The claws need to be cleaned for 2 to 3 weeks.
7. Replace the claws after working 1 to 2 million rivets.