Instructions:
ready
A. After cooling the tool, unscrew the nut.
B. The two knife blades are inserted into the two knife leg spin
Nut. Make sure the blade and knife holder full contact. If the knife leg
Is not properly installed, the blade will not be heated.
C. power
Cutting
A. Avoid direct contact with the two knife leads to a short circuit.
B. The temperature control knob to the middle position, the blade on the cutting object, and then press the switch. It is recommended to test the waste.
C. When cutting is best to keep the temperature and speed of harmonization. If you smoke too much, it may be because the cutting blade speed is too slow or the temperature is too high. This may cause irregular cutting path, not flat, this situation, you can lower the temperature or the cutting blade intermittently release the switch. When finished cutting the distance 3-5CM, release the switch.
D. Use wire brush to clean the blades.
Precautions:
A. Always use this tool in a ventilated environment.
B. Do not burn residual debris on the blade, otherwise the blade will bend.
C. Do not dry blades, please contact cutting was then heated.
D. Do not touch the blade, do not put hot blade placed in clothes, or next to the combustibles.
E. Please handle blade after blade cooling, in order to avoid accidental injury
F. Do not make a red-hot blade without cutting materials.
maintenance:
KD-5-3 knife prolonged use may result in cutting the material deposition on the blades, these residues can affect the performance of the blade and the knife holder. Use wire brush to completely remove residue.